Restore consistent heat output and low-odour performance with this 208V heater element. Purpose-built for Incinolet 208V models, it delivers the heat needed for complete incineration and clean venting. For correct fit, verify 208V on your data plate and include your serial number with the order. The manual notes that 208V units generally use 240V parts, except the 208V heater HEA009 and the 120V blower motor MOT006. 

Key Features

Dedicated 208V heater element, HEA009; not interchangeable with 120V or 240V heaters. 

Supports thorough incineration and reduced exterior odour when venting is installed correctly. 

OEM specification, serial-number confirmation recommended at checkout. 

Service friendly, installation steps are documented in the owner’s manual. 

Compatibility

For 208V Incinolet models; confirm voltage on the data plate.

Manual guidance, 208V units use 240V parts except HEA009 heater and MOT006 blower motor; always confirm your serial number. 

What’s Included

1 × Heater Element, HEA009 (208V).

Installation & Care, Quick Tips

Unplug the unit; remove ashpan, side access panel and top. 

Remove the old heater, then seat the new heater correctly in the brackets; coils must not touch each other. Re-install insulation and terminal cover, reattach the orange heater leads as specified. 

Re-install the thermocouple and ensure its tip contacts the outer surface of the lower heater coil. Reassemble and run a test cycle. 

For longevity, incinerate after each use and keep ash below about 2 inches. 

Specs

Voltage, 208 VAC.

Part number, HEA009. 

FAQs

How do I confirm this is the correct heater?

Check your data plate for 208V, then choose HEA009 and provide your serial number for confirmation. The manual clarifies the 208V exceptions noted above. 

Where is the heater located and how is it installed?

Inside the chamber on a bracket set, accessible by removing the top and side access panel; follow the manual’s steps for seating, wiring and thermocouple placement. 

Do 208V units use other 240V parts?

Yes, per the manual, 208V units use 240V parts in most cases, except the HEA009 heater and MOT006 blower motor.