Measure the center-to-center distance between your drive and driven pulleys, then calculate the required belt perimeter using the standard formula: Perimeter ≈ 2 × C + π × (D1 + D2) / 2, where C is center distance and D1/D2 are pulley pitch diameters. This product is available in perimeters from 3936mm (≈154.96") to 4002mm (≈157.56") in 3mm increments. When in doubt, size up and adjust center distance — over-tensioning a belt that is too short will accelerate wear.

The continuous steel cord tensile member typically provides significantly higher tensile strength than fiberglass-reinforced belts of the same width. Exact rated load capacity depends on pulley diameter, operating speed, wrap angle, and duty cycle. In most cases, a 30mm-wide HTD3M steel-cord belt is suited for light-to-medium power transmission. Contact us to confirm load ratings for your specific application before ordering for high-load or safety-critical uses.

The polyurethane body generally offers better resistance to oils, mild chemicals, and moderate moisture than standard rubber belts. However, prolonged exposure to standing water, direct UV radiation, or temperatures outside the typical operating range (−20°C to +80°C / −4°F to +176°F) may reduce belt service life. For outdoor or wash-down environments, contact us to confirm suitability before purchase.

Yes — this belt follows the HTD (High Torque Drive) 3M profile standard: 3mm pitch with a rounded curvilinear tooth shape. It is compatible with any HTD3M-spec pulley. It is not interchangeable with GT2, MXL, T3, or other pitch profiles, even if the tooth count appears similar. Always verify the pulley profile designation before ordering.

Belt width directly affects power transmission capacity and lateral stability. A 30mm-wide HTD3M belt is generally suited for applications requiring higher torque transfer or where the belt must resist lateral wandering — such as wide-format CNC gantry drives or conveyor indexing systems. For lighter-duty motion control (e.g., small desktop 3D printers), a narrower belt may be sufficient. In all cases, match belt width to your pulley face width for best tracking and even tooth wear.

This belt uses the HTD3M profile: 3mm pitch (tooth-to-tooth distance measured at the pitch line) with a curvilinear (rounded) tooth shape. The HTD profile is designed to reduce tooth stress concentration compared to trapezoidal profiles, making it well-suited for higher-torque, lower-backlash synchronous drive applications. The 3mm pitch also provides fine linear resolution per pulley revolution — a key reason HTD3M belts are widely used in CNC axis drives and 3D printer motion systems.

No. Closed-loop (endless) timing belts cannot be cut and rejoined without specialized splicing equipment. The steel cord tensile member runs continuously around the full loop perimeter — cutting it compromises tensile integrity and renders the belt unsafe for use. Select the perimeter size closest to your calculated requirement from the variant options above, and adjust your drive's center-to-center distance to achieve correct belt tension.